LaserCutting.
Clean edges. Tight nesting. DXF to cut part, fast.
Our 4,000W CNC laser cuts steel up to 1" thick on sheets up to 60"×120". Clean, accurate parts with minimal dross and no secondary edge cleanup for most jobs — ready to go straight into forming, welding, or assembly.
Materials & Thickness
What We Cut
The numbers
that matter.
Specs you can actually use to confirm we're the right shop for your job — before you even pick up the phone.
* New laser technology coming soon — increased capacity and material range.
See Fabrication ServicesFile in.
Parts out.
Send us your DXF or drawing and we handle the rest — programming, nesting, cutting, and staging for your next operation. No back-and-forth, no delays.
Send Your File
DXF, DWG, or PDF works. We review the geometry, confirm material and thickness, and flag any features that need attention before cutting begins.
Program & Nest
Parts are programmed and nested for material efficiency. Tight nesting means less scrap, which keeps your per-part cost down on production runs.
Laser Cut
Parts are cut on the 4,000W CNC. Clean, accurate edges with minimal heat-affected zone — most parts go straight to the next operation without cleanup.
Stage or Ship
Parts staged for forming, welding, or machining in-house — or packaged and shipped to you. Most jobs turn around in 1–3 business days.
Common Applications.
Fabrication Blanks
Plates, brackets, and gussets laser cut and ready for forming, welding, or machining. Clean edges improve fit-up and reduce downstream prep time.
Structural Profiles
Complex structural shapes cut from plate — coped ends, slotted tabs, and notched profiles that would take hours on a manual torch or plasma table.
Precision Parts
Tight-tolerance flat parts with complex features, close hole positions, and fine detail — held accurate part to part across the entire run.
Production Runs
High-volume repeat cutting nested for maximum material efficiency. Consistent edge quality and dimensions from first part to last — no drift over a run.
Prototypes
One-off prototype parts cut same-day or next-day from your DXF. No tooling, no setup delay — from file to finished cut in hours, not weeks.
Replacement Parts
Legacy or obsolete flat parts re-cut from original dimensions or reverse-engineered measurements. Exact match to the original, ready to install.
Send us your
DXF.
Drop us a file and tell us your material, thickness, and quantity. We'll confirm we can cut it and quote it — usually the same day you send it.